Covid-19 Signs

Use TroLase, TroLase Foil, and TroGlass to quickly create Covid-19 signs with these templates.


Required material

Sign "Wash your hands" Variant 1

  • 1/4 sheet TroLase black/yellow 1.6 mm L704-206
  • 1/4 sheet TroLase blue/white 1.6 mm L512-206 with double-sided adhesive foil on the back
Required material

Sign "Wash your hands" Variant 2

Required material

Sticker "Keep distance"

Machine used:
  • Speedy 300
  • 80 watts
  • 1.5" lens
  • Aluminum cutting grid table or honeycomb cutting tabletop

This sample can be produced with any other machine of the Speedy laser engravers.


When working with TroLase or TroLase Foil, keep the following in mind: The vacuum table works best if you're using the entire work surface, keeping the material flat over the entire surface. Otherwise, you can cover the work surface with paper to create an optimal vacuum.

Covid-19 Signs


Download now

Step by step

Step 1

Step 1: Import/Create Print & Laser Template

Use the template we provided or create a design of your own. Then use the settings below to send the job to the laser.
Important: If you use TroGlass Reverse, the file must be mirrored.

Print settings

Process mode Resolution Cut line
standard 500dpi none
Halftone Other
- Optimized geometries,
inner geometries first
Step 2

Step 2: Laser process

The laser parameters may vary based upon the laser system and laser power available.
Remove the protective material from the TroLase Foil or TroLase surface and place the material in your laser. If you use TroGlass Reverse, wait until after the laser process to remove the protective material.

Laser Parameters:

Material Color Process Power (%) Speed (%) ppi/Hz Passes Air Assist Z-Offset Direction Advanced
TroLase Foil black Engrave CO2 55 80 500 1 off 1.5 bottom to top -
  red Cut CO2 40 1 2000 1 on 0 - -
TroLase black Engrave CO2 65 80 600 1 off 1.5 bottom to top -
  red Cut CO2 60 1 2000 1 on 0 - -
TroGlass Reverse black Engrave CO2 18 20 500 1 on 0 bottom to top -
   red Cut CO2 60 1 2000 1 on 0 - -
Step 3

Step 3: Assembly

Before you attach the pieces together, take the the blue TroLase shield and remove the protective film on the back of it. Next, follow the markings to stick the TroLase label onto the yellow TroLase or the white TroGlass Reverse label.
Now the signs are good to go!

There is a wide range of color combinations to use. Feel free to get creative!

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo