Dress up your mobile phone with this exclusive leather case. Personalize the pouch with your initials for an individual touch. Check out our instructions and templates below to engrave your own.
11 x 6 inch piece of microfiber e.g. Alcantara®
Used Trotec Laser
- Speedy 300
- 80 watts
- 2 inch lens
Leather Phone Case
Step by step
Step 1: Preparing the cutting file
Download the template for the phone case. Open it in your preferred graphics software and personalize it as you wish.
Step 2: Laser cut the leather
Send the graphic file to the laser software with the parameters recommended below. Please note that the parameters may vary depending on the machine used and the laser power available.
Engraving parameters (black graphic)
Power: 40 %, Speed: 80 %, Resolution: 500 ppi, air assist: ON
Cutting parameters (red lines)
Power: 40 %, Speed: 4 %, Frequency: 1000 Hz, air assist: ON
Step 3: Assemble the parts
To finalize your engraved phone case by folding the two leather pieces and stitch them together along the dotted line which has been perforated by the laser. Do the same for the key chain.
- Use a 1.5 inch lens for intricate engraving details
- High laser power guarantees perfectly sealed edges