Easter decoration

Looking for inspiration for a contemporary Easter decoration? Check out our tutorial on how to create a colorful Easter decoration using LaserPaper and TroGlass satin acrylic sheets. Here you can download FREE graphic templates and instructions.

Preparation

Material used

LaserPaper Maple
1/4 sheet TroGlass Satins lemon green with adhesive
1/4 sheet TroGlass Satins light pink with adhesive
1/4 sheet TroGlass Satins yellow with adhesive
Picture frame (e.g. RIBBA 40x50 from IKEA)
Cover material for the laser

Machine used

Speedy 360
80 watts
2" lens
Aluminum Cutting Grid Table or Honeycomb Cutting Tabletop for LaserPaper
Acrylic gutting grid for TroGlass Satins

This sample can be made on any machine from the Speedy laser engraver series.

Easter Egg Decoration

ZIP

Download now

ZIP

Download now

Step by step

Step 1

Step 1: Import the design

Open up our template and adjust it to your requirements. Send the job to the laser using the driver settings below.

Tip:

Put the sheet in 0/0 position and place the job to the same position on the plate in JobControl. Due to the size the paper will not be cut.

Print settings:

Process mode:	Resolution:	Cut line:
Standard	500dpi	none

Halftone:	Others:
Color	-

Laser engraved LaserPaper for easter decoration

Step 2

Step 2: Laser process LaserPaper

The laser parameters may vary depending on the type of laser machine and the laser power available.

Laser Parameter	Color	Process	Power (%)	Speed (%)	ppi/Hz
Engraving	black	Engrave CO₂	60	100	500
Positioning	blue	Positioning	-	-	-

Passes	Air Assist	Z-Offset	Direction	Advanced
1	ON	3	top down	-
-	-	-	-	-

Step 3

Step 3: TroGlass Satins

Use the driver settings below to send the job for the three different TroGlass colors to the laser.

Print settings:

Process mode	Resolution	Cut lin
Standard	500dpi	none

Halftone	Others
Color	enhanced geometries

Step 4

Step 4: Laser process TroGlass Satins

The laser parameters may vary depending on the type of laser machine and the laser power available.

Laser Parameters: Cutting

Color	Process	Power (%)	Speed (%)	ppi/Hz
red	Cut CO₂	50	0,2	5000

Passes:	Air Assist	Z-Offset	Direction	Advanced
1	ON	-	-	-

Step 5

Step 5: Assembly

Begin by putting the LaserPaper into the picture frame. After that add the acrylic circles onto the engraved ones on the paper, largest to smallest. Align each of them to the center.

Tip:

Make the picture more stable by adding a thin plasitc sheet behind the LaserPaper. Now you're finished with this colorful easter decoration.

Why should I use Trotec materials?

Benefit from our laser-friendly paper and our versatile acrylic glass plates, which are especially suitable for the laser process.
Our wide TroGlass range is available in numerous colors and with different surfaces or degrees of transparency. The LaserPaper used consists of a real wood surface with a white cardboard on the back and enables extraordinary results in printing, cutting and engraving.