See our lasers in action!
Laser engraver and cutter
Speedy series: laser engraving and cutting machines for formats up to 40 x 24 inches
| ⚫ Engrave | ⚫ Cut | ⚫ Mark |
| Laser type: | CO₂, Flexx or Fiber laser |
|---|---|
| Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
| Max. workpiece height: | 4.9 - 12.0 inch |
| Laser power: | 20 - 120 watts |
Large-format laser cutter
SP series: CO2 laser cutter for large-format materials.
| ⚫ Engrave | ⚫ Cut | ⎯ Mark |
| Laser type: | CO₂ laser |
|---|---|
| Work area: | 49.0 x 28.0 up to 87.0 x 126.4 inch |
| Max. workpiece height: | 2.0 - 4.4 inch |
| Laser power: | 40 - 400 watts |
Industrial marking laser
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
| ⚫ Engrave | ⎯ Cut | ⚫ Mark |
| Laser type: | CO₂ or Fiber laser |
|---|---|
| Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
| Max. workpiece height: | 9.8 - 30.1 inch |
| Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Laser engraved
wedding glass
Wedding Glass
This tutorial shows you how to enhance the appearance of simple glasses with an individual engraving for weddings and other special events.
Preparation
Required material
- rotary attachment
- champagne glass
- paper towel
- a sponge or a spray and some water
Trotec laser used
- Speedy 300
- 80 watts
- 2.0 inch lens
Tip:
Use a 2 inch lens instead of a 1.5 inch lens to prevent cracking in the glass.
Step by Step
Step 1: Mount the rotary attachment
To mount the rotary attachment and plug it in, the laser has to be switched off. After that you can switch on the laser and put the prepared glass into the rotary attachment.
Step 2: Prepare the glass
To prepare the glass you will need a paper towel, and some water and a sponge or a spray bottle. To prevent splintering of the glass, apply a paper towel on the surface and moisten it. To improve your results, make sure there are no air inclusions or wrinkles.
Step 3: Put the glass into the rotary attachment
Put your prepared glass into the rotary attachment and make sure that it is firmly attached. If your glass is conical, adjust the inclination angle until the surface you want to engrave is in a parallel position.
Step 4: Engrave your glass
Next, import the PDF file into Corel Draw and customize it as you want. You could also make your own design and send it to the laser. Make sure that you have activated the rotary attachment and entered the diameter of the glass in the properties dialog (see screenshot in the slideshow above).
Used engraving parameters:
Power: 100% - Speed: 60% - Frequency: 500 ppi - Air Assist: OFF