Wall Decoration: Letters

Cut out beautiful wall decorations using colorful TroGlass and wall distance holders.


Preparation

Material used:

  • 3 pcs. of different colored TroGlass
  • R15-15-FL distance holders

Machine used:

  • Speedy 400
  • 120 watts
  • 2" lens
  • vacuum table with acrylic cutting grid table

As always, this pattern can be duplicated on all of the Speedy laser engraver series.


Step by Step

Step 1: Import the graphic file

Import our graphic file and adjust it to your requirements. Use the driver settings below to send each job to the laser.

Print Settings

Process mode Resolution Cut line
Standard 500dpi none
Halftone Others
Color Optimized Geometries, inner geometries first

Steps 2: Laser process

The laser settings may change depending on the laser machine used and the laser power available.

Laser parameters:

Color Process Power (%) Speed (%) ppi/Hz
red Cut CO2 100 1,2 5000
Passes Air Assist Z-Offset Direction Advanced
1 ON - - -

 

 


Step 3: Assembly

Using the back plate, mark where you need to drill the holes in your wall. Fix the distance holders to the wall with the plate. Now secure the colored acrylic letters to the distance holders using an Allen key. Making this decoration with distance holders is as easy as that!


Inspiration

Experiment with different sizes, fonts, and Trotec materials. The possibilities are limitless!


Check out the Speedy laser engravers

See our lasers in action! Request a demo now
Request a demo now