Decorate your lobby, shop, or home with this unique Christmas tree application this holiday season. (Find engraving materials for this and other applications at: www.engraving-supplies.com.)
Preparation
Required material:
3 sheets of 3mm TroGlass 1200mm x 600mm (Pick from any color. Use the remaining material for your decorations)
Each laser engraving machine is unique, so you may have to adjust the slots to suit the lens you are using.
Step by Step
Step 1: Import /create design template
Feel free to use your own tree design or import our provided template. Send it to the laser with the recommended laser parameters. Settings can vary depending on the machine used for processing and the available laser power.
Print settings:
Process mode
Resolution
Cut line
Standard
500 dpi
None
Halftone
Others
Black & White
Enhanced Geometries Inner - Geometries First
Step 2: Laser process
Place and position the material onto your laser bed. Proceed to cover the rest of the table to increase the exhaust power. You will need 6 side pieces - 2 on each sheet, and 4 disks. Remove the protective foil after the cutting is complete.
Laser Parameters:
Color
Process
Power (%)
Speed (%)
ppi/Hz
red
Cutting CO2
100%
0.65
10,000
Passes
Air Assist
Z-Offset
Advanced
1
on
-
-
Info:
The material parameters of JobControl can be downloaded from www.troteclaser.com
Step 3: Post-processing
To assemble your new Christmas tree, friction-fit each section into the discs. The largest disc should be located at the base.
Please not that the disc located at the peak of the tree contains two extra slots to secure the decorative star topper.
Inspiration
Now, it is time to decorate your new creation. Use your own ornaments, or decorate it with individually produced TroGlass ornaments. There is a selection of examples provided at the bottom of the page, but feel free to create you own designs!
