Speedy series: laser engraving and cutting machines for formats up to 40 x 24 inches
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
Max. workpiece height: | 4.9 - 12.0 inch |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 49.0 x 28.0 up to 128.0 x 126.4 inch |
Max. workpiece height: | 2.0 - 4.4 inch |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
Max. workpiece height: | 9.8 - 30.1 inch |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Step by step guide
Dress up your mobile phone with this exclusive leather case. Personalize the pouch with your initials for an individual touch. Check out our instructions and templates below to engrave your own.
11 x 6 inch piece of microfiber e.g. Alcantara®
Download the template for the phone case. Open it in your preferred graphics software and personalize it as you wish.
Send the graphic file to the laser software with the parameters recommended below. Please note that the parameters may vary depending on the machine used and the laser power available.
Engraving parameters (black graphic)
Power: 40 %, Speed: 80 %, Resolution: 500 ppi, air assist: ON
Cutting parameters (red lines)
Power: 40 %, Speed: 4 %, Frequency: 1000 Hz, air assist: ON
To finalize your engraved phone case by folding the two leather pieces and stitch them together along the dotted line which has been perforated by the laser. Do the same for the key chain.