Create this unique decoration with your laser cutter and experiment with light and shade.
- 3 mm acrylic
Trotec laser used
- Speedy 300
- 60 watts
- 2.0 inch lens
- Use the 2.0" lens f Evonik'sor an accurate cut quality
- We used radiant plexiglass.
Open the template file and send it to the laser. Select your favorite color, and then start cutting the acrylic. The laser parameters may vary, depending on the machine used and the available laser power.
To fit in the socket of the light bulb, emboss the edge with cutting lines. This is an alternative to engraving the area. Thanks to the defocusing, the laser beam is wider and the cutting lines overlap. That's how the "engraving effect" can be done with cutting lines.
Used cutting parameters:
Blue: power: 100 %, speed 0.7 %, frequency 9000 Hz, Air Assist on
Red: power: 60 %, speed 1.0 %, frequency 9000 Hz, Air Assist on, z-offset 3 mm
Assembling the acrylic lamp is easy. The assembling instruction helps.