Speedy series: CO2 laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Create a jewelry pendant as individual as its wearer
This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.
TroLase Reverse gloss/gold 1.6mm, waxed cord or a ribbon
Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections
Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.
Note that the cutting gap has been optimized for TroLase Reverse 1.6mm. When using other materials it may be necessary to adapt parameters and geometries.
We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:
Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On
Additionally we activated the optimized geometries-function to achieve an even higher quality.
It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.
To cut the stand, you can also use our template.
To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the overhanging ends with scissors short.
In the pictures below we have omitted the ribbon, so you can see the assembly better.