Customer-specific laser system for marking and cutting of foils

Customer-specific laser system for marking and cutting of foils for electronic devices. CO2 and fiber lasers work together in one processing field.

For 3-layer films, our customer was looking for a solution that would allow him to mark and cut the material at optimized speed and in a single operation. Different laser sources (e.g. CO2 and fiber laser) are required for marking and cutting. Therefore, without further ado, both laser sources were combined in one device.

Challenges:

Marking and cutting of the foils in one operation without a subsequent process.
Convenient and simple operation
Individual designs, if required also serially

The Trotec Solution

Up to now, two laser sources in one machine have only been available with flatbed lasers. This combination is not yet available in the standard high-speed laser machines. Our specialists therefore developed a customized laser solution with 2 laser sources. Both sources simultaneously access a processing field of 500 x 500 mm (lens focal length 635). A special CO2 laser source is used for cutting in the KissCut process and for the complete separation of the individual layers. For marking, the fiber laser source is used. An external passive roll feed transports the film laminate into the system, where it is marked and cut and automatically ejected at the other end.

Advantages for our customers

Minimized workload with maximum flexibility

All working steps in one operation

No handling between two production machines

About the Trotec Customer Competence Center

The expert department takes care of customer requirements that cannot be implemented with the Trotec standard machines. In most cases, the electroforming specialists use the modular system of the SpeedMark series for the development of such systems. However, if necessary, completely new designs are also developed.