Covid-19 Signs

Here you will find templates for the quick creation of Covid-19 signs from TroLase, TroLase Foil and TroGlass.

Preparation

Required material

Sign "Wash your hands" Variant 1

  • 1/4 sheet TroLase black/yellow 1.6 mm L704-206
  • 1/4 sheet TroLase blue/white 1.6 mm L512-206 with double-sided adhesive foil on the back
Required material

Sign "Wash your hands" Variant 2

  • 1/4 sheet TroGlass reverse glossy/white
  • 1/4 sheet TroLase blue/white 1.6 mm with double-sided adhesive foil on the back
  • Acrylic paint in black
Required material

Sticker "Keep distance"

  • 1/4 sheet TroLase Foil red/white 0.2 mm
Machine used:
  • Speedy 300
  • 80 watts
  • 1.5" lens
  • Aluminum cutting grid table or honeycomb cutting tabletop

This sample can be produced with any other machine of the Speedy laser engravers.

Tip:

When working with TroLase or TroLase Foil, the following applies: If you use the entire work surface, use a vacuum table or an adhesive mat so that the material lies flat over the entire surface. Otherwise, cover the work surface with paper to create an optimal vacuum.

sign-wash-hands-keep-distance.zip

ZIP

Download now

Step by step

Step 1

Step 1: Import/Create Print & Laser Template

Create your own design or use our template. Now send the job to the laser with the settings below.
Important: If you use TroGlass Reverse, the file must be mirrored.

Print settings

Process mode Resolution Cut line
standard 500dpi none
Halftone Other
- Optimized geometries,
inner geometries first
Step 2

Step 2: Laser process

Now make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.
Remove the protective foil from the TroLase Foil or TroLase surface and then place the material in your laser. If you use TroGlass Reverse it is recommended to remove the foil after the laser process.

Laser Parameters:

Material Color Process Power (%) Speed (%) ppi/Hz Passes Air Assist Z-Offset Direction Advanced
TroLase Foil black Engrave CO2 55 80 500 1 off 1.5 bottom to top -
  red Cut CO2 40 1 2000 1 on 0 - -
TroLase black Engrave CO2 65 80 600 1 off 1.5 bottom to top -
  red Cut CO2 60 1 2000 1 on 0 - -
TroGlass Reverse black Engrave CO2 18 20 500 1 on 0 bottom to top -
   red Cut CO2 60 1 2000 1 on 0 - -
Step 3

Step 3: Assembly

To attach the parts to each other, first remove the protective film on the back of the blue TroLase shield. Now stick the TroLase label onto the yellow TroLase or the white TroGlass Reverse label according to the markings.
The signs are now ready for use!

You can of course produce these signs in all possible colour and material combinations.

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo