Laser engraved
Mirror Glass

Step by step guide

mirror engraving with laser

Priprema

Required material
  • Mirror
  • Acrylic lacqueur
Trotec laser used
  • Speedy 100 flexx
  • fiber laser
  • 30 watts
Tip

Use the 2.85 inch flexx lens or the 3.2 inch fiber lens

glass-mirror-JC.zip

ZIP

Preuzmite odmah
csm_glass-mirror_97be2aa537.png

PDF

Preuzmite odmah

Detaljni vodič

mirror engraving with laser
Korak 1

Step 1: Preparation

First, put in the area you want to engrave a piece of anodized aluminum. Like this you do not engrave the work area too. Alternatively, you can also work with the honeycomb table. Then, you set the mirror with the mirror side facing up into the laser.
After that you can engrave the mirror reflective side up side through the glass with your desired pattern. Glass does not react with the fiber laser, and so only the mirror layer is removed by the laser. The glass itself is not scratched because it reacts only to the wavelength of the CO₂ laser source.

laser engraved glass coaster
Korak 2

Step 2: Used Laser Settings

Engraving:

Power: 100 %, speed: 10 %, frequency: 1000 ppi

mirror laser engraved
Korak 3

Step 3: Cleaning

The cleaning afterwards is very easy because the erosion and dust of the engraving lands on the table under the mirror and not on the mirror itself.

mirror with laser engraving
Korak 4

Step 4: Painting

The last step involves the painting. You apply acrylic lacquer to the back of the mirror. The final result: The mirror layer is removed due to the engraving. This part of the mirror is now transparent. So the colors of the paint remain bright and intense because of the transparency of the glass.

Serija Speedy
Idealan laserski graver i sekač za personalizaciju.

Otkrijte laserske gravere i sekače

Da li imate pitanja o aplikacijama ili podešavanjima?
Drago nam je što možemo da vam pružimo detaljne savete, od Air Assist-a do z-pomaka.

Kontaktirajte nas
Ponosni član troGROUP Logo