Laser engraved
glass bottles

Step by step guide

laser engraving on ikea bottle

Priprema

Required material
  • Glass bottle lass bottle MILDRA from IKEA, or any other colored glass bottle you like
  • Paper towel and a sponge or spray
Trotec laser used
  • Speedy 400
  • 80 watts
  • 2.0 inch lens
  • Rotary attachment
glass-bottle-JC.zip

ZIP

Preuzmite odmah
csm_glass-bottle_4336b50c0d.png

PDF

Preuzmite odmah

Detaljni vodič

Step 1

Step 1: Preparation

First mount the rotary attachment and plug it in. Make sure you turn the laser off before you do this. After that, you can switch on the laser.
Then apply a damp paper towel on the surface of the bottle and use a sponge or spray to moisten the towel. This will help prevent the glass from splintering and help you get a white engraving. Make sure there are no air bubbles or wrinkles.
Next put the bottle into the rotary. It may be necessary to adjust the inclination angle to bring the engraving surface in a parallel position. 

Step 2

Step 2: Settings

Import the PDF file into Corel Draw. You can personalize it with a quote or take your own design and send it to the laser. Make sure that you have activated the rotary attachment and entered the diameter of the glass in the properties dialog.

Laser Settings

We used a Speedy 400 with 80 Watts laser power with the following parameters:
Engraving: Power: 100% - Speed: 60% - Frequency: 500 ppi - Air Assist: OFF

Serija Speedy
Idealan laserski graver i sekač za personalizaciju.

Otkrijte laserske gravere i sekače

Da li imate pitanja o aplikacijama ili podešavanjima?
Drago nam je što možemo da vam pružimo detaljne savete, od Air Assist-a do z-pomaka.

Zatražite više informacija.

Ponosni član troGROUP Logo