halloween lantern detail

Halloween lantern

In this tutorial we will show you how to make a spooky Halloween lantern. For this lantern, we used TroGlass Color Gloss in Orange and Black. You will find the graphic file and the JobControl® laser parameters at the end of the page.


Required material
  • 1/4 sheet of TroGlass Color Gloss black or orange
  • Acrylic glue
Machine used
  • Speedy 400 80 watt
  • 2" lens
  • Vacuum table with acrylic cutting grid

Use the 2" lens for best cutting results.
Remove the protective foil on the back of the acrylic after cutting. This prevents the material from being scratched.

Candle Holder Halloween


Preuzmite odmah

Detaljni vodič

halloween lantern driver settings
Korak 1

Step 1: Preparation

Import our graphic or create your own design. Remove the protective foil from the front of the acrylic and put the material into the laser.
Send the job to the laser using the settings below.

Print settings

Process mode Resolution Cut line
Standard 500 dpi none
Halftone Others
Color Optimized geometries, inner geometries first
halloween lantern detail
Korak 2

Step 2: Laser process

Define the necessary parameters. They might vary depending on the machine used and the available laser power.

Laser Parameters

Color Process Power (%) Speed (%) ppi/Hz
black Cut CO2 16 20 500
red Cut CO2 50 0.2 5000
Passes Air Assist Z-Offset Advanced
1 on - -
1 on - -
Halloween lantern
Korak 3

Step 3: Assembly

Remove the protective foil from the back of the material. Clean the pieces with a damp cloth and mild detergent. Assemble the five pieces and use the acrylic glue to fix them. Your Halloween lantern is ready to scare your guests!

Serija Speedy
Idealan laserski graver i sekač za personalizaciju.

Otkrijte laserske gravere i sekače

Da li imate pitanja o aplikacijama ili podešavanjima?
Drago nam je što možemo da vam pružimo detaljne savete, od Air Assist-a do z-pomaka.

Kontaktirajte nas
Ponosni član troGROUP Logo