Speedy serije: CO2 mašine za lasersko graviranje i sečenje za formate do 1016 x 610 mm
⚫ Graviranje | ⚫ Sječenje | ⚫ Markiranje |
Tip lasera: | CO₂, Flexx ili Fiber laser |
---|---|
Radna površina: | 610 x 305 do 1016 x 610 mm |
Maks. visina predmeta: | 125 - 305 mm |
Snaga lasera: | 20 - 120 W |
SP serije: CO₂ mašine za lasersko sečenje za materijale velikog formata.
⚫ Graviranje | ⚫ Sječenje | ⎯ Markiranje |
Tip lasera: | CO₂ laser |
---|---|
Radna površina: | 1245 x 710 do 3250 x 3210 mm |
Maks. visina predmeta: | 50 - 112 mm |
Snaga lasera: | 40 - 400 W |
SpeedMarker serije: Industrijsko, brzo lasersko obeležavanje za označavanje metala i plastike.
⚫ Graviranje | ⎯ Sječenje | ⚫ Markiranje |
Tip lasera: | CO₂ ili Fiber laser |
---|---|
Maks. radno područje: | 190 x 190 do 1300 x 450 mm |
Maks. visina predmeta: | 250 - 764 mm |
Snaga lasera: | 20 - 100 W/20W MOPA |
Some applications require a strong vacuum, while others need powerful suction through the exhaust slots. To achieve the perfect result, use the air flow shutter to control the extraction air flow.
The Trotec air flow shutter regulates the air flow between the exhaust system and the 75-mm exhaust connection on the Speedy 300, Speedy 400 or SP500 when using a vacuum table.
Adjusting the air flow shutter is easy. By reducing the air flow on this exhaust connection, the suction at the table is automatically increased, creating higher vacuum or increasing the extraction of fumes from the table, respectively.
This leads to an improved hold of films, paper and other thin materials. In addition, the cutting quality with acrylic or other plastic materials is increased as the resulting fumes are extracted immediately, leading to clear and shiny cutting edges.
Effects
Full suction at the vacuum table No extraction via the exhaust slots in the processing area
When to use
Ideal for cutting
Effects
When the air flow shutter opening is narrow, more pressure will act at the vacuum table, and less fume will be removed in the processing area.
When to use
Ideal for combining engraving and cutting with low dust generation
Effects
Suction at the table and in the processing area are normal, as if no air flow shutter were installed
When to use
Ideal in case of strong dust development, e.g. when engraving stamp rubber
Need more help?
Contact the Trotec service hotline where top qualified and motivated laser experts will assist you with any questions or problems.