Halloween lantern

In this tutorial we will show you how to make a spooky Halloween lantern. For this lantern, we used TroGlass Color Gloss in Orange and Black. You will find the graphic file and the JobControl^® laser parameters at the end of the page.

Priprema

Required material

1/4 sheet of TroGlass Color Gloss black or orange
Acrylic glue

Machine used

Speedy 400 80 watt
2" lens
Vacuum table with acrylic cutting grid

Tips

Use the 2" lens for best cutting results.
Remove the protective foil on the back of the acrylic after cutting. This prevents the material from being scratched.

Candle Holder Halloween

ZIP

Preuzmite odmah

ZIP

Preuzmite odmah

Detaljni vodič

Korak 1

Step 1: Preparation

Import our graphic or create your own design. Remove the protective foil from the front of the acrylic and put the material into the laser.
Send the job to the laser using the settings below.

Print settings

Process mode	Resolution	Cut line
Standard	500 dpi	none

Halftone	Others
Color	Optimized geometries, inner geometries first

Korak 2

Step 2: Laser process

Define the necessary parameters. They might vary depending on the machine used and the available laser power.

Laser Parameters

Color	Process	Power (%)	Speed (%)	ppi/Hz
black	Cut CO₂	16	20	500
red	Cut CO₂	50	0.2	5000

Passes	Air Assist	Z-Offset	Advanced
1	on	-	-
1	on	-	-

Korak 3

Step 3: Assembly

Remove the protective foil from the back of the material. Clean the pieces with a damp cloth and mild detergent. Assemble the five pieces and use the acrylic glue to fix them. Your Halloween lantern is ready to scare your guests!

Serija Speedy
Idealan laserski graver i sekač za personalizaciju.

Otkrijte laserske gravere i sekače

Da li imate pitanja o aplikacijama ili podešavanjima?
Drago nam je što možemo da vam pružimo detaljne savete, od Air Assist-a do z-pomaka.

Kontaktirajte nas