--------------------------
  1. Trotec Laser
  2. Eroforrasok
  3. Laserski projekti
  4. Tea Light Holder

Laser-Cut Wooden
Tea Light Holder

This playful wooden tea light holder is your ideal gift for Valentine's Day.

Here you can find instructions and template files for laser cutting. If you wish, you can additionally engrave a personal message or a date on the tea light holder. We have used alder wood for this application. If you use a different wood type, you might have to adapt the laser parameters slightly.

diy.preparation

Required material
  • 3 mm alder wood
  • 1 tea light
Used Trotec Laser
  • Speedy 300
  • 60 watts
  • 1.5 inch lens
Tips
  • Use the 1.5 inch lens
  • Use a light and hard wood type to achieve a marked contrast of the cutting edges 
Tea-Light-Holder-template.pdf

PDF

diy.downloadNow
wood-tea-light-holder-JC.zip

ZIP

diy.downloadNow

diy.steps

diy.step

Step 1:

Open the cutting template and send it to the laser. Use the laser parameters indicated below for cutting and engraving. The parameters might vary depending on the laser machine used and its power category.

LASER SETTINGS

Engraving (black) - power: 90 %, speed: 50 %, resolution: 500 dpi, exhaust system: on
Cutting (red) - power: 95 %, speed: 1 %, frequency: 1000 Hz, exhaust system: on, correction: 10 

diy.step

Step 2:

Once you have cut and engraved the parts you can assemble them.

Serija Speedy
 Savršeni stroj za lasersko graviranje i rezanje za personalizaciju.

Otkrijte strojeve za lasersko graviranje i lasersko rezanje
Author Image

Imate li pitanja o primjenama ili postavkama?
Rado ćemo vas savjetovati o svim mogućim pitanjima, bilo da se radi o laserskom softveru Air Assist ili parametru z-offset.

Kontaktirajte nas
trogroup troGROUP Logo