Décoration de Noël découpée au laser : sapin de Noël en bois avec un ornement en acrylique

Create your own design or use our template. Send the graphic to the laser with the following print settings:

Tip:

In order for the tree to hold well after cutting the base plate, simply measure the thickness of the wooden plate in advance. As a guideline, you can start with a cutting gap of approximately 0.2mm when cutting with a 2inch lens.

Now enter the parameter settings. Please note the laser parameters may vary depending on the laser machine used and the power available.

Tip:

For more contrast in the engraving, lift the Z-Offset to about +4mm.

Use our template and design, or why not create your own? Send the graphics to the laser machine with the following print settings:

Send the parameters for the bauble decoration to the laser machine. Be aware the settings may be different depending on the laser machine used and power available.

Laser parameters: Cutting 

Place the tree in the base plate, and hang the bauble with the hook from the tree branch. You now have your own festive decoration!