Stamps for paper bags

Create your own design or use our free template. A tip for creating your own design: strong, not too detailed motifs and fonts are best. Avoid too fine lines - a lot of material will be removed, too thin lines can become unstable.
Find more information in our tips & tricks section: stamp engraving

Now send the job to the laser with the settings below.

Print settings:

Make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.

Insert the laser rubber Aero+ 5 mm into the machine. Make sure that it can no longer slip, as in this process the stamp rubber is vaccuumed off after each engraving pass. A fixation can be achieved by this:

• an extraction system with good extraction performance (Atmos Duo Plus)
• Glueing the rubber plate with adhesive tape
• Use of an adhesive mat (available from Trotec)

Cover the remaining work surface to create vacuum

Laser engraving process - four passes:

Set the "Cut" to "Skip" in the parameter settings. Focus and position the laser, then start the first engraving pass. After engraving, vacuum well the dust on the rubber plate with a vacuum cleaner. Make sure that the rubber does not slip. Now repeat the engraving process three more times.
Note: focus again before each pass (on the new level) and vacuum the stamp plate after each pass.

Laser process - cut:

After the engraving the cut takes place. Activate "Cut CO₂"" in the parameter settings and skip "Engrave CO₂".

Laser parameters:

Remove the laser rubber from the laser device and then clean it with a fine brush and water. After drying, glue the stamp plate onto the stamp.
Stamp a few times on a kitchen paper. Then the stamp is ready for use!