Get in the mood for spring by decorating your table with laser cut butterfly napkin rings and flower cutlery bags. With these cheery table top decorations the spring mood will stay in your home... even during rainy days!
Preparation
Required material:
4 mm polyester felt in two colors
Used Trotec Laser:
Speedy 400
40 watts
2 inch lens
Step by Step
Spring decoration: laser cut and engraved.
Step 1:
Open the file „Spring“ in your graphic programme and send it to the laser. Parameters may vary depending on the machine used and the laser power available.
Laser Settings
Black (engraving): Power: 60 %, Speed: 50 %, Resolution: 500 dpi, air assist: ON
Red (cutting): Power: 60 %, Speed 1.1 %, Frequency 1000 Hz, air assist: ON, correction 20
The textile cutting edge: clean and without fringes
Step 2:
To assemble the parts, you need just a few steps. The table decoration is designed to fit perfectly without adhesive.
The felt is laser engraved and cut in only one job.
Tips:
Use the 2 inch lens.
Our suggestion is to use polyester felt. You will get a clean cutting edge and a great engraving result.
The use of the honeycomb table prevents the felt rub off on the processing table. The material does not cover all over the table and the cutting gap fits perfectly because there is no radiant heat from the table.
