Felt and Leather
Christmas Boot
Step by step guide
There are numerous creative laser ideas for the Advent season: Surprise your loved ones with a Christmas boot cut with the laser from leather and felt, filled with Christmas delicacies.
Preparation
Required material
- red polyesterfelt, approx 4mm
- white Alcantara leather
- green wool, approx. 2 mm thick
Used Trotec Laser
- Speedy 300
- 60 watts
- 2 inch lens
Tips
We recommend the use of 100% polyester felt as it is especially suited for processing with the laser.

Step by Step

Step 1:
Open the file "Christmas boot" and send it to the laser. The boot is made from two different materials; we have started with the red boot. The red felt is engraved and cut.
LASER SETTINGS
- Engraving (black) - Power: 20 %, speed: 50 %, resolution: 500 ppi
- Cutting (red) - Power: 65 %, speed: 3 %, resolution: 1000 Hz
The parameters depend on the used machine and the available laser power; they might therefore vary.

Step 2:
Next, we laser cut the brim of the boot.
LASER SETTINGS
- Cutting (red) - Power: 65 %, speed: 3 %, resolution: 1000 Hz.
The parameters depend on the used machine and the available laser power; they might therefore vary.

Step 3:
Now all you need is a thick wool thread to stitch the different parts together.