Speedy-serien: CO? lasergraverare och -skärare för format upp till 1016 x 610 mm.
⚫ Gravera | ⚫ Skär | ⚫ Markera |
Lasertyp: | CO₂, Flexx eller Fiber laser |
---|---|
Arbetsyta: | 610 x 305 upp till 1016 x 610 mm |
Arbetsstycke maximal höjd: | 125 - 305 mm |
Lasereffekt: | 20 - 120 watt |
SP-serien: CO2 laserskärare för material i storformat.
⚫ Gravera | ⚫ Skär | ⎯ Markera |
Lasertyp: | CO₂ laser |
---|---|
Arbetsyta: | 1245 x 710 upp till 3250 x 3210 mm |
Arbetsstycke maximal höjd: | 50 - 112 mm |
Lasereffekt: | 40 - 400 watt |
SpeedMarker-serien: Industriell höghastighetslasermärkning av metaller och plast.
⚫ Gravera | ⎯ Skär | ⚫ Markera |
Lasertyp: | CO₂ eller Fiber laser |
---|---|
Max. arbetsyta: | 190 x 190 upp till 1300 x 450 mm |
Arbetsstycke maximal höjd: | 250 - 764 mm |
Lasereffekt: | 20 - 100 watt / 20 + 100 watt MOPA |
Some applications require a strong vacuum, while others need powerful suction through the exhaust slots. To achieve the perfect result, use the air flow shutter to control the extraction air flow.
The Trotec air flow shutter regulates the air flow between the exhaust system and the 75-mm exhaust connection on the Speedy 300, Speedy 400 or SP500 when using a vacuum table.
Adjusting the air flow shutter is easy. By reducing the air flow on this exhaust connection, the suction at the table is automatically increased, creating higher vacuum or increasing the extraction of fumes from the table, respectively.
This leads to an improved hold of films, paper and other thin materials. In addition, the cutting quality with acrylic or other plastic materials is increased as the resulting fumes are extracted immediately, leading to clear and shiny cutting edges.
Effects
Full suction at the vacuum table No extraction via the exhaust slots in the processing area
When to use
Ideal for cutting
Effects
When the air flow shutter opening is narrow, more pressure will act at the vacuum table, and less fume will be removed in the processing area.
When to use
Ideal for combining engraving and cutting with low dust generation
Effects
Suction at the table and in the processing area are normal, as if no air flow shutter were installed
When to use
Ideal in case of strong dust development, e.g. when engraving stamp rubber
Need more help?
Contact the Trotec service hotline where top qualified and motivated laser experts will assist you with any questions or problems.