Modern fruit bowl from solid wood

Tip lasera:	CO₂, Fiber ili Flexx laser
Radna površina:	610 x 305 do 1016 x 610 mm
Maks. visina predmeta:	125 - 305 mm
Snaga lasera:	10 - 120 W

Tip lasera:	CO₂ laser
Radna površina:	1245 x 710 do 3250 x 3210 mm
Maks. visina predmeta:	50 - 112 mm
Snaga lasera:	40 - 400 W

Tip lasera:	CO₂ ili Fiber laser
Maks. radno područje:	190 x 190 do 1300 x 450 mm
Maks. visina predmeta:	250 - 764 mm
Snaga lasera:	20 - 100 W/20W MOPA

In this tutorial we will show you how you can produce a modern solid wood fruit bowl with your Trotec laser. The parts are connected without glue.

Preparation

Required Material:

1 sheet of solid wood walnut 5 mm

Used machine:

Speedy 360, 80 Watts with 2.0" lens
Aluminum cutting grid table

The fruit bowl can of course also be produced with all other machines of the Speedy laser engravers or SP laser cutters.

Important:

Cover the working are completely with paper. By doing this even slightly bent sheets get flat.

Korak po korak

Step 1: Import design

Import our design template into your graphic program and adapt it according to your requirements. We used the free Autodesk Software 123D Design und 123D Make. Send the graphic to JobControl^® using the following parameters.

Print settings

Process	Resolution	Cut line
Cut Job	1000dpi	none

Halftone	Others
color	enhanced geometries

Info:

Wood is a natural product. It characteristics can vary. We recommend to test the parameters before you produce the work piece.

Step 2: Laser process

Set the parameters like described below. The laser parameters may vary depending on the type of your laser machine and available laser power.

Laser Parameters:

Color	Process	Power (%)	Speed (%)	ppi/Hz
red	cutting CO₂	100	0.70	1000

Passes	Air Assist	Z-Offset	Advanced
1	on	-	enhanced geometries

Step 3: Post-processing

Clean the parts while they are still in the machine and the vacuum is on. By doing this you can efficiently wipe over the complete surface. Sort the different parts and put them together.

Tip:

It is helpful to mark the front of the single pieces with adhesive tape so that you can assemble the pieces correctly.

Inspirations

Cut the bowl out two different types of wood and mix the parts during assembly.
Adding an engraving design or a name to the pieces creates a great effect. You can produce the bowls in advance and can add your customer's individual engraving afterwards.