This tutorial shows you how to engrave and laser cut cardboard to make a stable chair out of it.
- 2 pieces of
2mm corrugated cardboard
Trotec laser used
- Speedy 300
- 30 watts
- 1.5 inch lens
Print the first page of the PDF document (the engraving layout) in size of 610 x 300mm. Adjust the marker to the job and engrave it.
After the engraving part you have to turn around the cardboard horizontally and cut the cardboard (cutting file on the second page of the PDF document).
Then place the second cardboard sheet for cutting of the cross-brace elements in the laser. These are on the third page of the PDF document.
Import the PDF file into Corel Draw, customize it as you want to or take your own design and send it to the laser.
Front of the first cardboard
Engraving: Power: 40% - Speed: 100% - Frequency: 500 ppi - Air Assist: OFF - Z-Offset: 6mm
Back of the first cardboard
Cutting-in: Power: 7% - Speed: 3% - Frequency: 5000 Hz - Air Assist: OFF - Z-Offset: 6mm
Cutting: Power: 10% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON
Cutting: Power: 20% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON
Now you can use your cardboard chair for everything you want.
Make it in another scale - then you can sit on it yourself because it is so stable.
Visit kurtl.com and have a look at a range of creative furniture out of cardboard.
Use the vacuum table with the honeycumb tabletop for cutting and engraving the cardboard. You have to engrave the front of the cardboard and cut it on the back. That's why you have to turn it around after engraving and cut it on the other side.