You want to make a special sports trophy? In this tutorial we show you how you can make an impressive award out of individual acrylic layers.
- Acrylic 3mm Beige
- 2 binding screws (shaft diameter: 5 mm, length: 40 mm)
- 20 x washers (external diameter: 10 mm)
Trotec laser used for this application
Speedy 400flexx, 120 watts, 2” lens
Tip: Use an acrylic cutting grid table or acrylic slat cutting table
Choose which colors you want to use for the trophy. Ensure that there is a good contrast between the individual layers.
When ordering, ensure that the TroGlass Satins 3mm Lemon Green Translucent sheet already has double-sided adhesive film on one side.
Performance: 5%, Speed: 1%, Frequency: 1000 Hz, Air Assist: ON, Z-Offset: 4mm
Performance: 30%, Speed: 0.2%, Frequency: 5000 Hz, Air Assist: ON
The parameters can be downloaded directly in the download section and imported into your JobControl® material database.
Select these two options in JobControl® to get perfect cutting results.
- Optimized geometries
- Inner geometries first