--------------------------
room divider laser cut from wood

Room divider screen

Korak po korak vodič

Priprema

Required material
  • 12 sheets of 18" x 24" prefinished wood,
    1/8" thick
  • 1 sheet of 12" x 24" frosted acrylic
  • at least 50 brass "S" hooks
  • Drop ceiling hangers or permanent hooks for a solid ceiling
Used Trotec Laser
  • Speedy 400
  • 80 watts
  • 2.5 inch lens
csm_room-divider_1956962588.png

PDF

Preuzmite odmah

Korak po korak

room divider from acrylic and wood
Korak 1

Step 1: Create the layout

Using the panel sizes provided, create a layout in a graphics program like a puzzle. We have provided the layout used in this sample here, but you can create any combination to fit your space. Make sure that you place the location of the connecting holes!

room divider from laser cut wood
Korak 2

Step 2: Create each panel

Adjust the connecting holes to fit each panel. Create a new copy of each panel and adjust the connecting holes by using guides in your graphics program and the layout. Label each panel with a number to ensure that you have accounted for each one.

laser cut wooden room divider
Korak 3

Step 3 - User Settings

Cut out the panels.

Mahogany Wood Panels

Cutting: Power: 100% - Speed: 0.9% - Frequency: 2500 Hz - Air Assist: ON

Acrylic Panels

Cutting: Power: 50% - Speed: 0.2% - Frequency: 20000 Hz - Air Assist: ON

assembly wooden room divider
Korak 4

Step 4 - Assemble the Panels

Layout the panels on the floor to ensure that everything lines up. Start with the top panels and connect the to the ceiling using the hooks. Work across and then down, using the "S" hooks to connect the panels. Once completed, stand back and admire the view!

Tips

  • Using pre-finished wood means that there are less finishing step for top quality results
  • Cleaning off the smoke residue before lifting the panels out of the lasers with a damp cloth makes it easier to see if you missed any spots.
  • Using pliers to manipulate the "S" hooks while assembling makes it easier for the panels to be attached together.
  • Using frosted acrylic instead of wood for a few panels adds a nice decorative touch.

Serija Speedy
Savršeni stroj za lasersko graviranje i rezanje za personalizaciju.

Otkrijte strojeve za lasersko graviranje i lasersko rezanje

Imate li pitanja o primjenama ili postavkama?
Rado ćemo vas savjetovati o svim mogućim pitanjima, bilo da se radi o laserskom softveru Air Assist ili parametru z-offset.

Kontaktirajte nas
Ponosni član troGROUP Logo