Die plates for
seal presses

Engrave your own custom die plates for seal presses

seal press laser engraved

Add an individual touch to your letters and invitation cards with a stylish embossing. We show you how to engrave your own die plates for seal presses with your Trotec laser.

In case you are interested in more information on seal presses visit the Trodat website.

Priprema

Potrebni materijal

Standard Delrin sheets for engraving and cutting out the embossing plates, a seal press, high-quality paper

Korišteni Trotec laser
  • Speedy300
  • 60 vata
  • 1.5 inč leća
Seal Press Plates

ZIP

Preuzmite odmah
Seal Press Template

PDF

Preuzmite odmah

Korak po korak

embossing tool engraved delrin
Korak 1

1. korak: Cut and engrave the embossing plates

Create your own design for the die plates or use the one we've prepared for you. Then send it to the laser with the parameters below for cutting and engraving. The laser parameters may vary, as they depend on the machine used and the available laser power.

PREPORUČENI PARAMETRI:

Graviranje: Crno: snaga 60%, brzina 20%, 500 ppi, Air Assist uključen

Rezanje: Red: snaga 50%, brzina 1,0%, frekvencija 1000 Hz, Air Assist uključen

engraved paper seal press
Korak 2

2. korak: Ljepilo the plate to the seal press

Take the newly made die plate out of the laser and clean it thoroughly. Simply wash the finished Delrin die plates with water and a little soap or dish liquid and wipe off any still adhering dust with a brush. After gluing the plate to your seal press you can start embossing fini papirs.

film embossing with seal press
Korak 3

Alternative: Engrave a text plate for a rubber stamp

You can also use the embossing plate design for engraving a text plate for a rubber stamp. We've made a separate CorelDraw file for this. Make sure to adjust your laser to the parameters below when engraving the rubber text plate.

PREPORUČENI PARAMETRI:

Graviranje: Crno: power 100%, brzina 12%, 600 ppi, Air Assist uključen

Rezanje: Red: snaga 80%, brzina 0,7%, frekvencija 1000 Hz, Air Assist uključen

Serija Speedy
Savršeni stroj za lasersko graviranje i rezanje za personalizaciju.

Otkrijte strojeve za lasersko graviranje i lasersko rezanje

Imate li pitanja o primjenama ili postavkama?
Rado ćemo vas savjetovati o svim mogućim pitanjima, bilo da se radi o laserskom softveru Air Assist ili parametru z-offset.

Kontaktirajte nas
Ponosni član troGROUP Logo