Verre pour boisson gazeuse gravé au laser
Guide étape par étape
Add value to inexpensive drinking glasses with decorations, names or designs. We have used the rotary attachment to add style to a 10 ¼ oz drinking glass (31 cl).
Donnez de la valeur à de simples verres avec une décoration, un nom ou un motif. Nous avons utilisé ici un verre de 10 ¼ oz (31 cl) avec un tourne-cylindre.
Préparation
Matériel
- Verre 10 ¼ oz ( 31 cl)
- Mouchoir en papier
- Eau
- Eponge
Laser Trotec
- Speedy 300
- 30 watts

Étape par étape

Etape 1
Prenez d'abord un mouchoir en papier légèrement humidifié. Pour l'humidifier, utilisez de préférence une éponge ou un vaporisateur. Posez le mouchoir en papier sur la surface que vous souhaitez graver par la suite. Cela évite que le verre ne se fendille pendant la gravure.

Etape 2
Installez le tourne-cylindre dans le laser. Allumez le laser. Vous pouvez maintenant fixer le verre dans le tourne-cylindre et faire la mise au point sur la surface. Si vous utilisez des verres coniques, faites pivoter le tourne-cylindre jusqu'à ce que la surface à graver soit parallèle au plateau de travail.

Etape 3
Ouvrez le fichier "BBQ Glass" et envoyez-le au laser. Assurez-vous que vous avez activé la gravure rotative dans le pilote et indiqué le diamètre du verre. Vous pouvez commencer la gravure.
NOUS AVONS UTILISÉ LES PARAMÈTRES SUIVANTES POUR LA GRAVURE SUR VERRE :
- Vitesse : 20 %
- Puissance : 100 %
- Résolution : 500 dpi

Etape 4
Dès que la gravure est terminée, enlevez le mouchoir en papier du verre.
Préparation
Required material
- 10 ¼ oz glass (31 cl)
- Paper towel
- Water
- Sponge
Trotec laser used
- Speedy 300
- 30 watts
- 2 inch lens

Étape par étape

Step 1: Preparation
First, take a slightly moist paper towel. Preferably use a sponge or a spray bottle for moistening. Place the paper towel on the surface that you wish to engrave later. This will prevent splintering of the glass during the engraving process.

Step 2: Rotary Attachtment
Place the rotary engraving attachment into the laser and insert it. Next, switch the laser on. You can now clamp the glass into the rotary attachment and focus on the surface. If you use a conical glass, tilt the rotary attachment until the engraving surface is positioned parallel to the work table.

Step 3: Used Laser Settings
Open the file "BBQ Glass" and send it to the laser. Make sure that the rotary attachment is enabled in the driver and that you have entered the correct diameter of the glass. You can now start the engraving process.
WE HAVE USED THE PARAMETERS INDICATED BELOW FOR ENGRAVING THE GLASS:
Engraving: Power: 100 %, Speed: 20 %, Resolution: 500 dpi

Step 4: Cleaning
As soon as the engraving is complete, remove the paper from the glass.