- TroGlass Duo 3mm Night and Day
- TroGlass Satins 3mm Black
- TroGlass Satins 3mm Lemon Green Translucent
- TroGlass Satins 3mm White
- Acrylic 3mm Beige
- 2 binding screws (shaft diameter: 5 mm, length: 40 mm)
- 20 x washers (external diameter: 10 mm)
Trotec laser used for this application
Speedy 400flexx, 120 watts, 2” lens
Tip: Use an acrylic cutting grid table or acrylic slat cutting table
Step 1: Preparation
Choose which colors you want to use for the trophy. Ensure that there is a good contrast between the individual layers.
When ordering, ensure that the TroGlass Satins 3mm Lemon Green Translucent sheet already has double-sided adhesive film on one side.
Step 2: Laser Process
Cut out the 15 elements from the acrylic sheets. For perfect results, we recommend using an acrylic cutting grid table. Cover the rest of the table and remove the protective film from the top side.
Performance: 5%, Speed: 1%, Frequency: 1000 Hz, Air Assist: ON, Z-Offset: 4mm
Performance: 30%, Speed: 0.2%, Frequency: 5000 Hz, Air Assist: ON
The parameters can be downloaded directly in the download section and imported into your JobControl® material database.
Select these two options in JobControl® to get perfect cutting results.
- Optimized geometries
- Inner geometries first
Step 3: Assembly
Put all cut TroGlass elements in the correct order and have the binding screws and washers ready. Then attach the different parts and layers to each other by fastening the screws.
Here's a short video to show how it can be done.