Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
In order to achieve the highest cut quality, the best possible vacuum is required in laser processing. The Table Exhaust takes care of this. With the SP3000 and SP2000 laser cutters, it is possible to activate the exhaust system only in specific zones of the work area.
With material that does not cover the entire work area, the open areas usually need to be covered manually for an efficient vacuum. This costs time and money in preparing the work. Thanks to the segmented exhaust system, the work area can be divided into four zones with the SP3000 and two zones with the SP2000. The segments can be individually activated by pressing a button on the operating console.
If the material to be cut covers only one segment, only this segment must be activated. It is no longer necessary to manually cover the surface. Thus, you achieve a perfect vacuum and the highest cut quality.
A well-thought-out exhaust system is the key for a clean and smooth cutting edge. The design of the SP4000 ensures the best extraction of dusts and gases. At the same time, the material is held down by vacuum to the laser bed to ensure process stability. The digital table exhaust can be segmented into four zones. This enables a perfect adaptation of the exhaust area to the fabric width and ensures a reliable cut even with narrow panels.
In addition to that, Trotec developed a travelling exhaust at the laser head especially for soft signage applications. It ensures efficient removal of smoke at its origin. The operator is protected and legal regulations are fulfilled – even at highest cutting speeds.