Laser type:	CO₂, Flexx or Fiber laser
Work area:	610 x 305 up to 1016 x 610 mm
Max. workpiece height:	125 - 305 mm
Laser power:	20 - 120 watts

Laser type:	CO₂ laser
Work area:	1245 x 710 up to 3250 x 3210 mm
Max. workpiece height:	50 - 112 mm
Laser power:	40 - 400 watts

Laser type:	CO₂ or Fiber laser
Max. work area:	190 x 190 up to 1300 x 450 mm
Max. workpiece height:	250 - 764 mm
Laser power:	20 - 100 watts / 20 + 100 watts MOPA

Heat transfer film
cut with a laser

Step by step guide

Decorate your textiles with your favourite designs, logos and lettering "screen-printing like".

Preparation

Required material:

LaserFlex film, T-Shirt, heat press

Used Trotec Laser:

Speedy 300
60 watts
2 inch lens
Vacuum table with honeycomb cutting table

Step by Step

Step 1: Engrave and Cut the LaserFlex

Create your own design or use our template. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.

Recommended parameters:

Engraving: Power: 50 %, Speed: 50 %, Resolution: 500 dpi, air assist on
Cutting: Power: 12 %, Speed 1 %, Frequency 1000 Hz, air assist on

film engraving with laser — Engraving the film from bottom to top for an optimal result

Step 2: Finish your textile application

Use a heat press for transferring the LaserFlex on textiles. Transfer the film for 17 seconds at 165°C / 329°F. Remove the liner when the material is completely cold.