See our lasers in action!
Laser engraver and cutter
Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
| ⚫ Engrave | ⚫ Cut | ⚫ Mark |
| Laser type: | CO₂, Flexx or Fiber laser |
|---|---|
| Work area: | 610 x 305 up to 1016 x 610 mm |
| Max. workpiece height: | 125 - 305 mm |
| Laser power: | 20 - 120 watts |
Large-format laser cutter
SP series: CO2 laser cutter for large-format materials.
| ⚫ Engrave | ⚫ Cut | ⎯ Mark |
| Laser type: | CO₂ laser |
|---|---|
| Work area: | 1245 x 710 up to 2210 x 3210 mm |
| Max. workpiece height: | 50 - 112 mm |
| Laser power: | 40 - 400 watts |
Industrial marking laser
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
| ⚫ Engrave | ⎯ Cut | ⚫ Mark |
| Laser type: | CO₂ or Fiber laser |
|---|---|
| Max. work area: | 190 x 190 up to 1300 x 450 mm |
| Max. workpiece height: | 250 - 764 mm |
| Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Laser engraved
Mirror Glass
Step by step guide
Your creativity knows no bounds: Even mirrors can become unique decorative elements with laser engraving.
Preparation
Required material
- Mirror
- Acrylic lacqueur
Trotec laser used
- Speedy 100 flexx
- fiber laser
- 30 watts
Tip:
Use the 2.85 inch flexx lens or the 3.2 inch fiber lens
Step by Step
Step 1: Preparation
First, put in the area you want to engrave a piece of anodized aluminum. Like this you do not engrave the work area too. Alternatively, you can also work with the honeycomb table. Then, you set the mirror with the mirror side facing up into the laser.
After that you can engrave the mirror reflective side up side through the glass with your desired pattern. Glass does not react with the fiber laser, and so only the mirror layer is removed by the laser. The glass itself is not scratched because it reacts only to the wavelength of the CO₂ laser source.
Step 2: Used Laser Settings
Engraving:
Power: 100 %, speed: 10 %, frequency: 1000 ppi
Step 3: Cleaning
The cleaning afterwards is very easy because the erosion and dust of the engraving lands on the table under the mirror and not on the mirror itself.
Step 4: Painting
The last step involves the painting. You apply acrylic lacquer to the back of the mirror. The final result: The mirror layer is removed due to the engraving. This part of the mirror is now transparent. So the colors of the paint remain bright and intense because of the transparency of the glass.