The above parameters refer to the Speedy 400 model. If you already have a Speedy 400 NEW (with Optimotion) in use, you can set the cutting parameters (red and green) to 80% power and 1.1% speed. The laser device regulates the required speed automatically.
Now make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.
Leave the protective film on the top and bottom of the TroGlass plate. Place the material on the acrylic grid cutting table in the laser machine. Cover the remaining area to create the best possible vacuum.
Cut the TroGlass in two steps: in the first laser process, skip the cutting color green so that the base plate (cutting colors red and blue) is cut first.
Then remove all parts from the laser unit. Now remove the protective film from the back of the remaining plate and apply a double-sided adhesive film instead. Place the remaining TroGlass plate back in the same position in your laser device (adhesive film on the underside). Start the laser process for the cutting color green (lettering), skipping the cutting colors red and blue.