Laser type:	CO₂, Flexx or Fiber laser
Work area:	24.0 x 12.0 up to 40.0 x 24.0 inch
Max. workpiece height:	4.9 - 12.0 inch
Laser power:	20 - 120 watts

Laser type:	CO₂ laser
Work area:	49.0 x 28.0 up to 128.0 x 126.4 inch
Max. workpiece height:	2.0 - 4.4 inch
Laser power:	40 - 400 watts

Laser type:	CO₂ or Fiber laser
Max. work area:	7.5 x 7.5 up to 51.2 x 17.7 inch
Max. workpiece height:	9.8 - 30.1 inch
Laser power:	20 - 100 watts / 20 + 100 watts MOPA

Laser Engraved
Party Sign

A friendly welcome for your guests

A friendly welcome for your guests. With different materials in different layers, your sign will look absolutely great! We have used different laminates in different colors.

Preparation

Required material:

Laminate walnut/white
Laminate green/white with double-sided adhesive tape on the back
Laminate silver/black with double-sided adhesive tape on the back
Water
Sponge

Used Trotec Laser:

Speedy 300
25 watts

Tips:

Use the 2.5" lens
Use a cutting table. You can thus prevent beam reflections on the back of the material.

Step by Step

engraved party sign — Laser engraved sign for your party

Step 1:

This sample consists of three layers. We will start with the top layer in silver. Open the file "BBQ Sign 3". If you wish to engrave your own photo, import it. Convert it to a black-and-white picture and use the "Floyd-Steinberg" as conversion model. Draw a contour (red hairline). Then start the engraving process. We have used the parameters below.

Laser Settings

Grid engraving: power 60 %, speed 30 %, resolution 500 dpi
Vector cut: power: 80 %, speed 1 %, frequency 9000 Hz

Step 2:

Next engrave the center layer of the sign in green/white. Open the file "BBQ Sign 2" and send it to the laser. We have used the parameters below.

Laser Settings

Grid engraving: power 40 %, speed 30 %, resolution 500 dpi
Vector cut: power: 80 %, speed 1 %, frequency 9000 Hz

engraved laminate in white & brown — Laser engraved laminate in maple/white

Step 3:

Now you can engrave the bottom layer of the sign (walnut/white). For this, open the file "BBQ Sign 1" and send the job to the laser. The used parameters are listed below.