3 mm acrylic (a perfect way for using material remnants)
Trotec laser used
- Speedy 300
- 60 watts
- 2.5 inch lens
- Use the 2.5" lens
- Use a cutting table. This will prevent beam reflections on the backside of the material.
Step 1: Cut the acrylic with the laser
Open the "acrylic-penbox" file and send it to the laser. You can start cutting the acrylic immediately. The laser parameters depend on the machine used and the available laser power; they may therefore vary.
Recommended cutting parameters (red):
Power: 100 %, speed 0.8 %, frequency 8500 Hz, Air Assist on