Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Step by Step instruction
Use the following guide to make these individual coasters using standard slate plates. We also produced the appropriate storage for the coasters.
For this sample you only can use any laser machine from the Speedy laser engraver series.
Make your own design or import our template. Adapt the graphic if necessary to the size of the slate sheets.
Then send the job to the laser using the driver settings below.
Process mode | Resolution | Cut line |
---|---|---|
Standard | 500 dpi | none |
Halftone | Others |
---|---|
Color | - |
Determine and enter the material parameter settings. The parameters can vary depending on laser machine and available laser power.
For faster production, engrave all coasters in one step. Since the individual pieces are not 100% identical, pay special attention to the precise positioning of the graphic.
Color | Process | Power (%) | Speed (%) | ppi/Hz |
---|---|---|---|---|
black | Engrave CO2 | 60 | 100 | 500 |
Passes | Air Assist | Z-Offset | Advanced |
---|---|---|---|
1 | on | - | - |
Make your own design or import our template. Adapt the graphic if necessary to the size of the slate sheets.
Send the job to the laser using the driver settings below.
Before cutting, measure the thickness of the wooden sheet and adapt the kerf if necessary. Also make sure that the slate coasters fit into the storage.
Process mode | Resolution | Cut line |
---|---|---|
Standard | 500 dpi | none |
Halftone | Others |
---|---|
Color | Optimized geometries, inner geometries first |
Make the material parameter settings. The parameters can vary depending on laser machine and available laser power.
Color | Process | Power (%) | Speed (%) | ppi/Hz |
---|---|---|---|---|
red | Cut CO2 | 95 | 0.3 | 1000 |
Passes | Air Assist | Z-Offset | Advanced |
---|---|---|---|
1 | on | - | - |
We used the standard parameters in JobControl for solid wood oak.
Connect the individual pieces of the storage box and put the laser engraved coasters into it.
You can use any design for the slate coasters. Laser engrave logos, images or other designs of your customers. In addition you can personalize the storage box for your customers with engravings.