business card case laser engraving

Precious paper
Business cards

Step by step guide

Impress your friends and colleagues with this individual paper finishing application. Precious paper laser engraved and cut.


Required material

Paper or cardboard, we used "Gmund Doubleface 925 brown, silver"

Trotec laser used

  • Speedy 300
  • 30 watts
  • 1.5 inch lens

Step by Step

Step 1:

Open the file "Bussines_Card" in your graphic programme, then send it to the laser. Please keep in mind that the settings for speed and laser power may vary depending on the machine used.

Laser Settings

Black (engraving):
power: 30 %, speed: 25 %, frequency: 500 dpi, air assist: on 

Red (cutting):
power: 30 %, speed: 5 %, frequency: 1000 Hz, air assist: on, Z-Offset: -2

Blue (cutting):
power: 25 %, speed: 1.5 %, frequency: 1000 Hz, air assist: on

Desert blue (cutting):
power: 40 %, speed: 2 %, fequency: 1000 Hz, air assist: on


  • Use the 1.5 inch lens. As a result, the detailed writings become particularly beautiful.
  • If you use conventional paper and not a special cardboard, our suggestion is to reduce the laser power.
  • The combination of the vacuum table and the honeycomb table leads to the best result.
  • Feel free to adapt the design! Be creative!

See our lasers in action! Request a demo now
Request a demo now