Make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.
Insert the laser rubber Aero+ 5 mm into the machine. Make sure that it can no longer slip, as in this process the stamp rubber is vaccuumed off after each engraving pass. A fixation can be achieved by this:
- an extraction system with good extraction performance (Atmos Duo Plus)
- Glueing the rubber plate with adhesive tape
- Use of an adhesive mat (available from Trotec)
Cover the remaining work surface to create vacuum
Laser engraving process - four passes:
Set the "Cut" to "Skip" in the parameter settings. Focus and position the laser, then start the first engraving pass. After engraving, vacuum well the dust on the rubber plate with a vacuum cleaner. Make sure that the rubber does not slip. Now repeat the engraving process three more times.
Note: focus again before each pass (on the new level) and vacuum the stamp plate after each pass.
Laser process - cut:
After the engraving the cut takes place. Activate "Cut CO2"" in the parameter settings and skip "Engrave CO2".