Take a simple bulb holder and produce an eye-catching ceiling light.
Photo cardboard or thick paper (approx. 180 - 300 g/m²)
IKEA bulb holder (cord set) HEMMA with LED bulb
Material to cover the engraving table (e.g. paper)
- Trotec Speedy 400
- 120 Watt
- Use a cutting table (honeycomb or acrylic grid) for best cutting results
- Use a 1.5 inch lens
Import our design templates into your graphic program and adapt it to the size of your lamp shade. Send it to the laser with the recommended laser parameters. The parameters might vary depending on the machine used and the available laser power.
Once you have positioned your paper into the laser machine, switch on the exhaust and cover the rest of the table with white paper to increase the exhaust performance.
Cut out the design from the paper. For the bulb holder you will need 5-6 paper stripes.
- power 17%
- speed 2.5%
- frequency 1000 Hz
- Air Assist on
Select these two options in JobControl® to get perfect cutting results.
- Optimised geometries
- Inner geometries first