See our lasers in action!
Laser engraver and cutter
Speedy series: laser engraving and cutting machines for workpieces up to 40 x 24 inches
| ⚫ Engrave | ⚫ Cut | ⚫ Mark |
| Laser type: | CO₂, Flexx or Fiber laser |
|---|---|
| Work area: | 24.0 x 12.0 up to 40.0 x 24.0 inch |
| Max. workpiece height: | 4.9 - 12.0 inch |
| Laser power: | 20 - 120 watts |
Large-format laser cutter
SP series: CO2 laser cutter for large-format materials.
| ⚫ Engrave | ⚫ Cut | ⎯ Mark |
| Laser type: | CO₂ laser |
|---|---|
| Work area: | 49.0 x 28.0 up to 87.0 x 126.4 inch |
| Max. workpiece height: | 2.0 - 4.4 inch |
| Laser power: | 40 - 400 watts |
Industrial marking laser
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
| ⚫ Engrave | ⎯ Cut | ⚫ Mark |
| Laser type: | CO₂ or Fiber laser |
|---|---|
| Max. work area: | 7.5 x 7.5 up to 51.2 x 17.7 inch |
| Max. workpiece height: | 9.8 - 30.1 inch |
| Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Laser Cut
Flower Coaster
Step by step guide
Create a beautiful laser cut flower coaster with a cork back to protect your table.
Preparation
Required material
- Two different coloured sheets of acrylic in any colour of your choice (1/8")
- Self-adhesive thin cork
Trotec laser used
- Speedy 300
- 80 watts
- 2.5 inch lens
Accessories
Cutting table or acrylic cutting grid table
Step by Step
Step 1: Design
Download the files below and scale them to fit the size coaster you would like.
Step 2: Laser settings
Acrylic Cutting:
Power: 35%, Speed: 0.3%, Frequency: 10000 Hz, Air Assist: ON
Cork Cutting:
Power: 25%, Speed: 4%, Frequency: 500 Hz, Air Assist: ON
Tip:
Make sure that you collect and save all of the inner pieces after cutting to use for assembly.
Step 3: Assemble
Once you have the pieces cut, remove the backing on the cork, and place the outer section of one color acrylic on it. Now use the inner sections of the opposite acrylic to fill in the spaces. The adhesive side of the cork will hold everything in place.
Tips:
- Use the pieces left over to create a second coaster.
- Make the graphic larger, and cut it out of thicker wood to create a trivet. Discard the inner pieces and put small rubber feet on the bottom to protect your table.
- You can also use felt to line the bottom of the coaster, just make sure to use adhesive on the outer and inner pieces to secure everything in place.