laser cut sports trophy from acrylic

Acrylic sports trophy

We show you how to make a fun and quirky sports trophy from our laserable acrylic material, TroGlass.


Required material:

Other materials:

  • Acrylic 3mm Beige
  • 2 binding screws (shaft diameter: 5mm, length: 40mm)
  • 20 x washers (external diameter: 10mm)

Trotec laser used for this application:

Tip: Use an acrylic cutting grid table or an acrylic slat cutting table.

Step by Step

Step 1: Preparation

First you need to choose which colours you would like to use for the trophy. We recommend using colours that provide a good contrast between the individual layers for a greater effect.


When ordering the TroGlass Satins 3mm Lemon Green Translucent sheet, ensure it has double-sided adhesive film on one side.

Step 2: Laser Process​

Proceed to cutting the 15 elements from the acrylic sheets. For perfect results, we recommend using an acrylic cutting grid table. Ensure that you cover the rest of the table and remove the protective film from the top side.

Laser Parameters:

Scoring (red):
Performance: 5%, Speed: 1%, Frequency: 1000 Hz, Air Assist: ON, Z-Offset: 4mm
Cutting (blue):
Performance: 30%, Speed: 0.2%, Frequency: 5000 Hz, Air Assist: ON

Note: You can download the parameters directly in the download section and import it into your JobControl® material database.


In order to get optimal cutting results, select the below options in JobControl®.

  • Optimised geometries
  • Inner geometries first

Step 3: Assembly

Place all of the cut TroGlass elements in the correct order and ensure the binding screws and washers are ready. Attach the different layers by fastening the screws.

This video demonstrates the assembly process.

See our lasers in action! Request a demo now
Request a demo now