Seal press plates

Engrave your own custom die plates for seal presses

seal press laser engraved

Add an individual touch to your letters and invitation cards with a stylish embossing. We show you how to engrave your own die plates for seal presses with your Trotec laser. If you would like more information on seal presses visit the Trodat website

Preparation

Required material
  • Standard Delrin sheets for engraving and cutting out the embossing plates
  • a seal press
  • high-quality paper
Used Trotec Laser
  • Speedy300
  • 60 watts
  • 1.5 inch lens
Seal Press Plates

ZIP

Download now
Seal Press Template

PDF

Download now

Step by step

delrin stamping pliers
Step 1

Step 1: Cut and engrave the embossing plates

Create your own design for the die plates or use the one we've prepared for you (to download click here). Then send it to the laser with the parameters below for cutting and engraving. The laser parameters may vary, as they depend on the machine used and the available laser power.

RECOMMENDED PARAMETERS:

Engraving: Black: power 60%, speed 20%, 500 ppi, Air Assist on

Cutting: Red: power 50%, speed 1,0%, frequency 1000 Hz, Air Assist on

embossing fine paper
Step 2

Step 2: Glue the plate to the seal press

Take the newly made die plate out of the laser and clean it thoroughly. Simply wash the finished Delrin die plates with water and a little soap or dishwashing liquid and wipe off any still adhering dust with a brush. After gluing the plate to your seal press you can start embossing fine papers.

embossed foil seal
Step 3

Alternative: Engrave a text plate for a rubber stamp

You can also use the embossing plate design for engraving a text plate for a rubber stamp. We've made a separate CorelDraw file for this (to download click here). Make sure you adjust your laser to the parameters below when engraving the rubber text plate.

RECOMMENDED PARAMETERS:

Engraving: Black: power 100%, speed 12%, 600 ppi, Air Assist on

Cutting: Red: power 80%, speed 0,7%, frequency 1000 Hz, Air Assist on

Speedy series
The ideal laser engraver and cutter for personalisation.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo