Speedy series: Laser engraving and cutting machines for formats up to 1016 x 610 mm
⚫ Engrave | ⚫ Cut | ⚫ Mark |
Laser type: | CO₂, Flexx or Fiber laser |
---|---|
Work area: | 610 x 305 up to 1016 x 610 mm |
Max. workpiece height: | 125 - 305 mm |
Laser power: | 20 - 120 watts |
SP series: CO2 laser cutter for large-format materials.
⚫ Engrave | ⚫ Cut | ⎯ Mark |
Laser type: | CO₂ laser |
---|---|
Work area: | 1245 x 710 up to 3250 x 3210 mm |
Max. workpiece height: | 50 - 112 mm |
Laser power: | 40 - 400 watts |
Marking laser stations with galvo marking heads. Marking area up to 44.1 x 25.0 inch.
⚫ Engrave | ⎯ Cut | ⚫ Mark |
Laser type: | CO₂ or Fiber laser |
---|---|
Max. work area: | 190 x 190 up to 1300 x 450 mm |
Max. workpiece height: | 250 - 764 mm |
Laser power: | 20 - 100 watts / 20 + 100 watts MOPA |
Step by step guide
Celebrate the new arrival with an extraordinary baby shower gift.
sheet of acrylic in any color you like (3 mm), double-sided adhesive tape, LED lights strand
honeycomb cutting table, acrylic cutting grid table
Import the PDF file into CorelDraw and select the desired graphic (see the tabs below the working area in CorelDraw). Scale to fit your acrylic piece (you will need a front and a back to fit on the piece).
Engraving: Power: 35% - Speed: 10% - Frequency: Auto - Air Assist: ON
Cutting: Power: 30% - Speed: 0.1% - Frequency: 8,500 Hz - Air Assist: ON
Put a honeycomb cutting table top into the laser and lasercut and engrave the front and back part out of the acrylic. If you use our ship design, you will find them on the second page of our PDF template.
To cut the stand, you can also use our template.
You need a few linking pieces to attach the front and back of the ship together with a space in the middle. Apply double-sided adhesive tape between two sheets of acrylic. Do not remove the protection film yet and cut the linking pieces.
Take the linking pieces out of the laser, remove the protection film and apply double-sided adhesive tape. Now you can stick the two ship halves with the linking pieces together. As a last step, put the lights around the linking pieces and affix the ship on the stand.
Your night light is ready to use!